Tag Archives: installation

MarkLevinson_585

Integrated Amplifier

Source text – English  Power Requirements The No585 is configured at the factory for 100, 115, or 230 VAC power operation at 50Hz or 60Hz. Before operating the amplifier, ensure that the power label on the rear panel near the AC input connector indicates the correct operating voltage. A detachable IEC power cable intended for […]

Read More

images-9

Ice Machine

Source text – English Location of Ice Machine Head Section The location selected for the ice machine head section must meet the following criteria. If any of these criteria are not met, select another location. The location must be free of airborne and other contaminants. The air temperature must be at least 1.6 degree C […]

Read More

images-12

Boat Brochure

Source text – English Simple Installation Remove existing drive from the boat, following the instructions in your Volvo manual. • Split the drive; remove the centre section; clean and prepare all mating surfaces. • Fit the new XX unit, using the new ‘O’ ring seals, shims and sealant provided. • Adjust the helm controls for new […]

Read More

images-13

Boat Drive Installation Instructions

Source text – English Simple Installation Remove existing drive from the boat, following the instructions in your Volvo manual. • Split the drive; remove the centre section; clean and prepare all mating surfaces. • Fit the new StepDrive unit, using the new ‘O’ ring seals, shims and sealant provided. • Adjust the helm controls for […]

Read More

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close